Construction Of A 3000mah Rechargeable Power Bank

power bank includes a main body having a circuit board and a battery arranged therein. The circuit board includes a first control unit, a second control unit connected to the first control unit.




power bank includes a main body having a circuit board and a battery arranged therein. The circuit board includes a first control unit, a second control unit connected to the first control unit. The first control unit controls an input voltage of an external power supply and an output voltage of a battery power of the battery, and informs the second control unit to turn on. Portable Power Banks are comprised of a special battery in a special case with a special circuit to control power flow. They allow you to store electrical energy (deposit it in the bank) and then later use it to charge up a mobile device.


1.0                                                        INTRODUCTION

Sometimes there is nothing worse than losing all the charges on your Smartphone especially when you are in the middle of something very important. Usually this happens at the most inconvenient time probably when you are using your phone to surf the web, in the middle of a phone call or when you are desperate to send an important email or text message. Nonetheless, in this dispensation of global village, there is never a good time!  If you are always on the move, the very last thing you would imagine is to have your Smartphone low or even empty on battery. For those who depend largely on their mobile devices, not having enough power for the battery can be a major catastrophe. How else will people reach you or how will you contact people for business or personal reasons when your phone is basically useless as it has gone off on you? All these are problem to our present time, to bring this problem to an end, powerbank was introduced which is a portable device that can supply USB power using stored energy in its built-in batteries. Powerbanks usually recharge with USB power.

1.2                                             OBJECTIVE OF THE PROJECT

The objective of the project is to design a device that is used to recharge small devices such as cellphone when and where there is no power supply to charge the device from mains supply. A connector is added to complete the design. The type of connector will depend on the device to be charged. Cell phones from Samsung and many other companies require the Micro-USB “type B” receptacle connector.

1.3                                         SIGNIFICANCE OF THE PROJECT

Power bank serve as an ‘extra battery’ or external charger for your phone or other electronic devices. Power bank helps to ensure longer hours of texting, phone calls, or web browsing using your mobile phone.

1.4                                                 SCOPE OF THE PROJECT

Cell-phone batteries often die at very inconvenient times, with no ac power outlet nearby. This device uses  standard AA batteries, which can be bought almost anywhere, to recharge cell phones and other portable devices like music players, e-book readers, and cameras.

The circuit chargers that typically come with cell phones and other portable devices charge the battery for a brief period of time. Then, they stop, check the voltage, and verify the temperature against an internal table before deciding to stop or continue the charging process. The charging regulation required by the battery is performed within the device getting charged, and this design takes advantage of that circuit.

1.5                                           LIMITATION OF THE PROJECT

  • it can only be recharged with mains supply
  • the duration of the charged when in used depend on the number of cell used.

1.7                          PROJECT WORK ORGANIZATION

The various stages involved in the development of this project have been properly put into five chapters to enhance comprehensive and concise reading. In this project thesis, the project is organized sequentially as follows:

Chapter one of this work is on the introduction to the study. In this chapter, the background, significance, objective limitation and problem of the study were discussed.

Chapter two is on literature review of this study. In this chapter, all the literature pertaining to this work was reviewed.

Chapter three is on design methodology. In this chapter all the method involved during the design and construction were discussed.

Chapter four is on testing analysis. All testing that result accurate functionality was analyzed.

Chapter five is on conclusion, recommendation and references.


There are no reviews yet.

Be the first to review “Construction Of A 3000mah Rechargeable Power Bank”

Your email address will not be published. Required fields are marked *